Author Topic: Honda ANF 125 wheels.  (Read 83 times)

Moogie38 (Noel)

  • Forum user
  • Posts: 275
  • Location: Northern Ireland

Badges: (View All)
CKGB Member
Honda ANF 125 wheels.
« on: 18 Aug 22, 09:21 pm »
Is anyone using the ANF wheels ?
Would it be possible to put the bearings where the oil seal was or would the housing not be strong enough ? Thinking that by putting the bearings further apart it would put less stress on the centre of the hub and keep the wheel steadier. You could fit 25 x 37 x 10 bearings.
Facebook: Cyclekarts Ireland.

Share on Facebook Share on Twitter


Chris Brown

  • Forum user
  • Posts: 483
  • Location: Llangadog

Badges: (View All)
CKGB Member
Re: Honda ANF 125 wheels.
« Reply #1 on: 18 Aug 22, 10:33 pm »
I've got some ANF125 front wheels, but they're odd ones out regarding bearings, fronts are 32mm both sides, rears are 37mm one side and 32mm the other. The fronts are quite good as the bearings are available in 17mm, 20mm, and 25mm bore, I'll probably press the bearings all the way in to the seats. There's probably enough width to fit two bearings each side given the width of the bearings, tabulation attached.

Moogie38 (Noel)

  • Forum user
  • Posts: 275
  • Location: Northern Ireland

Badges: (View All)
CKGB Member
Re: Honda ANF 125 wheels.
« Reply #2 on: 18 Aug 22, 10:48 pm »
Thanks Chris.
Noel.
Facebook: Cyclekarts Ireland.